Citrix ADC MPX 5550 User Manual

Citrix ADC MPX
7 next binding state free;
8 hardware ethernet 00:d0:68:11:f4:d6;
9 uid ”45eae1a8157e89b9314f”;
10 client-hostname ”45eae1a8157e89b9314f”;
11 <!--NeedCopy-->
In the preceding example, the binding state is ACTIVE and the IP address assigned to the appliance is
192.168.2.127.
The following table describes DHCP-related CLI commands that you might want to use when config-
uring a new Citrix ADC appliance.
Table 2. Citrix ADC CLI commands for using DHCP with a new Citrix ADC appliance
Task At the command prompt, type:
To verify the DHCP fetched details, such as IP
address, subnet mask, and gateway on the
appliance
> sh dhcpParams
To release the DHCP IP address and return it to
the IP address pool on the DHCP server when
the Citrix ADC configuration is complete
> release dhcpIP
Using DHCP when a configuration file is present
If you need to move a Citrix ADC appliance to a dierent subnet, you can use DHCP to access an ap-
pliance that already has a configuration file. Before moving the appliance, enable its DHCP client
and save the configuration. As a result, when the appliance restarts, it automatically polls the DHCP
server for an IP address. Enable the DHCP client and save the configuration before shutting down
the appliance. If you did not enable, you need to connect to the appliance through the console and
dynamically run the DHCP client on the appliance. The DHCP server provides an IP address, a gate-
way, and a subnet mask. You can use the IP address to access the appliance and configure the other
settings remotely.
If the DHCP client is enabled in the configuration file, disable it and then save the configuration file.
If the DHCP client is enabled, the appliance polls the DHCP server again for an IP address when it
restarts.
The CLI commands associated with each task are listed:
• To dynamically run the DHCP client to fetch an IP address from the DHCP server
set dhcpParams dhcpClient on
© 1999‒2022 Citrix Systems, Inc. All rights reserved. 155

Citrix ADC MPX 5550 Specifications

General

Brand	Citrix
Model	ADC MPX 5550
Category	Network Hardware
Language	English