Citrix ADC MPX 5550 User Manual

Citrix ADC MPX
or client-hostname field. Verify that the binding state in this entry is active. If the binding state is not
active but free, the IP address is not yet associated with the appliance.
You can use this address to connect to the appliance and remotely configure the initial settings. For
example, you can change the IP address, subnet mask, and gateway settings that were fetched from
the DHCP server. Aer completing the initial configuration, you can manually return the DHCP IP ad-
dress to the server pool. Alternatively, restarting the appliance automatically releases the DHCP IP
address back to the server pool.
You can find out the SNIP address assigned to the appliance from the Citrix ADC console or from the
DHCP server.
Find the SNIP address from the Citrix ADC console
At the console prompt, type:
1 sh dhcpParams
2 DHCP Client on next reboot is ON
3 DHCP Client Current State: Active
4 DHCP Client Default route save: OFF
5 DHCP acquired IP:192.168.2.127
6 DHCP acquired Netmask:255.255.255.0
7 DHCP acquired Gateway:192.168.2.1
8 Done
9 <!--NeedCopy-->
Find the SNIP address from the DHCP server
Look in the dhcpd.leases file for the last entry with the sysid of your appliance in the uid or client-
hostname field.
Example:
The following entry in a DHCP server’s dhcpd.leases file verifies the binding state of the appliance
whose sysid is 45eae1a8157e89b9314f.
1 lease 192.168.2.127 {
2
3 starts 3 2013/08/19 00:40:37;
4 ends 3 2013/08/19 06:40:37;
5 cltt 3 2013/08/19 00:40:37;
6 binding state active;
© 1999‒2022 Citrix Systems, Inc. All rights reserved. 154

Citrix ADC MPX 5550 Specifications

General

Brand	Citrix
Model	ADC MPX 5550
Category	Network Hardware
Language	English