CITROEN C2 2003 - Page 80

78
CHECKING AND SETTING THE VALVE TIMING
Engine : 8HY
B1EP18ZC
Checks (continued).
NOTE : The index «e» of the dynamic tensioner roller should be centred within the area «d».
Check the correct positioning of the index «e».
If it is not correct, repeat the operation to tension the timing belt (see corresponding operation).
Refitting.
Refit the tool [1] at «a».
Remove the screw (8).
Refit:
- The upper timing cover (11).
- The lower timing cover (10).
- The accessories drive pulley (9).
- The screw (8).
Tightening torque:
- Screw (8) :
Pre-tighten to : 3 ± 0,3 m.daN.
Angular tightening : 180° ± 5°.
Remove the tool [1].
ENGINE