135
ENGINE
AUXILIARY EQUIPMENT DRIVE BELT
Engines: 8HX - 8HWWith compressor and alternator.
B1BP2MKC
B1BP2MJD
Tools.
[1]
Pliers for removing plastic pegs : 7504-T
[2] Tensioner roller compression lever : (-).0194.E
[3] Tensioner roller setting peg Ø4 mm : (-).0194.F
Removing.
Disconnect the battery negative cable.
Raise and support the vehicle, wheels hanging.
Remove the front RH wheel.
Move aside the splash-shield, using tool
[1].
IMPERATIVE: In the case of belt re-use, mark the
direction of rotation of the belt. If the index on the
tensioner roller is outside the marks, change
the auxiliary equipment drive belt.
The alternator (1).
The aircon compressor (2).
Detension the auxiliary belt tensioner roller, using tool [2].
Position the peg [3].
Remove the auxiliary drive belt.
C2 - C3 - C3 PLURIEL
To Next Page
Loading...
