AXLES
SUSPENSION
STEERING
355
C2
AXLE GEOMETRY
Tyres inflated to correct pressures. Vehicle at reference height.
Steering rack locked at mid point (see corresponding operation).
Conditions for checking and adjusting
Vehicle heights at reference height
E1APOBZD
Front height Rear height
L1 L2
H1 = R1 – L1 H2 = R2 + L2
H1
= Measurement between the measuring zone underneath the front H2 = Measurement between the measuring zone underneath the rear
subframe and the ground. sill and the ground.
R1 = Front wheel radius under load. R2 = Rear wheel radius under load.
L1 = Distance between the wheel axis and the measuring zone L2 = Distance between the wheel axis and the measuring zone
underneath the front subframe. underneath the rear sill.
To Next Page
Loading...
