253
INJECTION
XSARACHECKING AND SETTING THE DELPHI MECHANICAL INJECTION PUMP
Tools.
[1]
Flywheel locating peg : 7014-T.J
[2] H M8 screw : (-).0188.E Tool kit C.0188
[3] Injection pump setting peg Ø 6 mm : (-).0188.H
After carrying out the necessary dismantling operations on the vehicle, proceed in the following manner:
Remove:
- The screws
(6), (7), (9), (10) and (12).
- The upper casing (8).
- The intermediate casing (11).
WARNING: Refit the screw (6) equipped with a washer. (Thickness 5 mm)
- Turn the front RH wheel to turn the engine. (Normal direction of rotation)
- Bring the camshaft and injection pump pulleys to their setting point.
- Position the flywheel peg, using tool
[1]. (From below the vehicle)
- Turn the engine until the peg [1] engages in the flywheel.
B1EP12NC
Engine: WJY
B1BP1S9C
To Next Page
Loading...
