351
CLUTCH
GEARBOX
TRANSMISSION
DRAINING / FILLING / TOP-UP: AL4 GEARBOX
Tools.
[1]
Filling cylinder : (-).0341
Draining.
IMPERATIVE: The gearbox should be drained when the oil is warm (at least 60°C), to
eliminate the impurities in suspension in the oil.
NOTE: Draining is partial, the converter cannot be completely emptied.
Remove the drain plug
(1).
NOTE: Approx. 3 litres of oil should flow out.
Filling.
Refit the drain plug (1) (equipped with a new seal), tighten to 2,4 ± 0,2 m.daN.
Remove the oil filler cap
(2).
Use tool [1].
Oil capacity for dry gearbox:
- EW engine: 5,85 litres.
- DW engine: 5,40 litres.
Oil remaining after draining:
3 litres (approx.).
Quantity of oil to be put in : 3 litres (approx.).
Refit the oil filler cap (2) (equipped with a new seal), tighten to 2,4± 0,2 m.daN.
Initialise the oil wear counter (follow the diagnostic tool procedure).
Engines: KFV - NFU - RFN - RHZ
C3 - XSARA - XSARA PICASSO
B2CP3AYD
B2CP31GC
To Next Page
Loading...
