CITROEN C2 2004 - Page 195

ENGINE
191
CHECKING AND SETTING THE VALVE TIMING
Engines: 8HX - 8HW - 8HZ
B1EP18LC B1BP2LZC
Setting the timing (continued).
Refit:
- The intermediate RH engine support, tighten the screws (16) to 5,5 ± 0,5 m.daN.
- The RH engine support, tighten the screws (17) to 4,5 ± 0,4 m.daN.
- The bottom timing cover (3).
Immobilise the engine flywheel, using tool [3].
Remove the screw (2).
Refit the accessories drive pulley and tighten to:
- Pre-tighten to : 3 ± 0,3 m.daN.
- Angular tighten to : 180° ± 1,8°.
Remove tool
[3].
Refit:
- The top cover (1).
- The accessories belt (see corresponding operation).
- The exhaust line (see corresponding operation).
- The front RH splash-shield.
- The front RH wheel.
C2 - C3 - C3 PLURIEL - XSARA