CITROEN C2 2004 - Page 203

ENGINE
199
CHECKING AND SETTING THE VALVE TIMING
Engines: 8HY - 8HV
B1EP18XC
Setting the timing (continued).
Chec
ks (continued).
Reposition the timing belt, belt at «e» well tensioned, in the following order:
- Guide roller (17).
- Camshaft pulley (16).
- Fuel high pressure pump pulley (15).
- Coolant pump pinion (18).
- Tensioner roller (19).
Remove the 5 mm diameter peg at «d».
Adjusting the fitting tension of the belt.
Action the tensioner roller (19) to align the marks «f» and «g», avoiding detensioning the timing belt,
with the aid of a male hexagonal spanner, at «c».
If this is not successful, repeat the operation to tension the belt.
Hold the tensioner roller in position (19).
Tighten the tensioner roller, tightening to 3,7 ± 0,3 m.daN.
Check the position of the tensioner roller (the alignment of the marks «f» and «g» should be correct).
Remove tools [2] and [3].
Turn the crankshaft six rotations (clockwise).
C3