CITROEN C2 2004 - Page 334

330
CLUTCH
GEARBOX
TRANSMISSION
CHECKS AND ADJUSTMENTS: BE4/5 GEARBOX CONTROLS
Tools.
[1]
Tool for positioning the gear lever : 9607-T.
Adjustements.
WARNING: Cables should be adjusted each
time the gearbox, gear controls or power unit
are removed.
Inside the vehicle:
- Remove the trim under the gear lever.
- Lock the gear lever in neutral position,
using tool
[1].
Under the bonnet:
- Remove the air filter assembly.
- Unlock the ball-joint keys at «a».
- Place the gear selection and control levers on
neutral.
- Lock the cable lengths with the ball-joint locking
keys.
Checks.
- Remove the tool [1].
- Check that all the gears engage without
«tightness ».
- Check that the gear lever moves identically
forwards and backwards and to right and left. If it
does not, repeat the adjustment.
- Refit the trim under the gear lever.
- Refit the air filter assembly.
Adjusting the gear controls
Engines: NFV - 6FZ - RFN - RFS - WJY - 8HZ - 9HZ - 9HY - RHY - RHZ
XSARA - XSARA PICASSO
B2CP3C6C
B2CP3C0C