120
In the event of a breakdown
Fitting a wheel
Fitting a steel or "space-saver" type
spare wheel
If the vehicle is tted with alloy wheels, the
washers A do not make contact with the steel
or "space-saver" type spare wheel. The wheel
is held in place by the conical contact surface
B of each bolt.
► Fit the wheel on the hub.
► Screw in the bolts by hand as far as possible.
► Pre-tighten the bolts using the wheelbrace 5
only.
► Lower the vehicle again fully.
► Fold jack 6 and remove it.
► Tighten the bolts using the wheelbrace 5 only.
► Ret the bolt covers to each of the bolts
(depending on equipment).
► Store the tools.
Putting the spare wheel
back in place
► Put the spare wheel back in place in its
housing.
► Slacken the nut on the bolt by a few turns.
► Position the fastening device (nut and bolt) in
the middle of the wheel.
► Tighten the central nut suciently to retain
the wheel correctly.
► Depending on version, put the tool box back
in place in the middle of the wheel and clip it in
place.
To Next Page
Loading...
