137
6
Driving
Displays on the instrument panel
Starting the vehicle
F With your foot on the brake pedal, select
position P or N.
F Start the engine.
If these conditions are not met, an audible
signal is issued together with a message.
If P is displayed on the instrument panel
but the gear selector is in another position,
move the selector to position P to allow
the engine to be started.
F With the engine running, press the brake
pedal.
F Select automatic mode (position D),
sequential mode (position M) or reverse
(position R).
If you do not press the brake
pedal when trying to move
the gear selector out of
position P, this warning lamp
or this symbol appears on
the instrument panel with the
message "Shift automatic
gearbox to P", the P symbol
flashes and a beep sounds.
F If the parking brake is released, the vehicle
moves off.
If the parking brake is applied and automatic
mode is activated, accelerate gradually.
If the parking brake does not release
automatically, check that the front doors
are properly closed.
Never press the brake and accelerator
pedals at the same time. Braking or
accelerating must be done with the
right foot only. Pressing the two pedals
simultaneously risks damaging the
gearbox.
If position R, D or M is selected when the
engine is running at idle, with the brakes
released, the vehicle moves even without
the accelerator being pressed.
Never leave children unattended in the
vehicle when the engine is running.
When carrying out maintenance with the
engine running, apply the parking brake
and select position P.
When you move the selector, the indicator
corresponding to its position is displayed on the
instrument panel.
F Check that the display on the instrument
panel agrees with the position engaged.
F Gradually release the brake pedal.
P. Parking.
R. Reverse.
N. Neutral.
D. Drive (Automatic operation).
1 to 6 or 8. Gears engaged during manual
operation.
-. Invalid value during manual
operation.
To Next Page
Loading...
