139
6
Driving
In sequential mode, it is not necessary to
release the accelerator pedal when changing
gear.
Changing from one gear to another only
occurs if the vehicle speed and engine speed
conditions allow; otherwise the gearbox will
operate temporarily in automatic mode.
If the engine speed is too low or too high, the
gear selected flashes for a few seconds, then
the gear actually engaged is displayed.
Invalid value during manual operation
This symbol is displayed if a gear
is not engaged correctly (selector
between two positions).
You can change mode at any time by
moving the gear selector from D to M or
vice versa.
Stopping the vehicle
door is opened or approximately 45 seconds
after the ignition is switched off, an audible
signal sounds and a message appears:
F reposition the lever to position P; the
audible signal stops and the message
disappears.
Whatever the parking circumstances, you must
apply the parking brake manually to immobilise
the vehicle if automatic operation has been
deactivated.
In all circumstances, ensure that the
selector is in position P before leaving
your vehicle.
Before switching off the engine, you can
engage position P or N to place the gearbox
in neutral. In both cases, apply the parking
brake to immobilise the vehicle, unless it is
programmed to automatic mode.
If the lever is not in position P, when the driver's
In the event of a battery failure, use the
chock to immobilise your vehicle.
Operating fault
If the gearbox malfunctions, the
Service warning lamp comes on in
the instrument panel, accompanied
by a message and an audible signal.
Do not exceed 62 mph (100 km/h), local speed
restrictions permitting.
Have it checked by a CITROËN dealer or
a qualified workshop.
In this case, the gearbox switches to back-up
mode and is locked in 3rd gear. You may then
feel a substantial jolt when changing from P to
R and from N to R. This jolt will not cause any
damage to the gearbox.
Gear efciency indicator
This system reduces fuel consumption by
recommending the most appropriate gear.
Operation
Depending on the driving situation and your
vehicle's equipment, the system may advise
you to skip one (or more) gear(s). You can
follow this instruction without engaging the
intermediate gears.
Gear efficiency recommendations are for
information only. In fact, the road layout, the
traffic density and safety remain the deciding
factors when choosing the best gear. The driver
therefore remains responsible for deciding
whether or not to follow the indications issued
by the system.
This function cannot be deactivated.
With an automatic gearbox, the system is
only active in manual mode.
To Next Page
Loading...
