64
Ease of use and comfort
From outside the vehicle
From the boot, for example when loading
F Give a firm upward pull on strap C, as
shown by the arrow, to unlock the seat;
keep pulling the strap until the seat is
completely folded. Push the backrest
slightly forward so that the backrest tilts
and folds over the cushion. The seat and
cushion fold down to the floor.
Replacing the seat
F If necessary, straighten the continuity
panels of the 2nd row of seats and lock
them.
F Raise the backrest and push it back until it
latches into place.
Before performing any operations on the
rear seats, to avoid damage to the seat
belts, make sure that the side belts are
properly tensioned. The central seat belt
must be put away. Secure the buckles
of the three seat belts to their anchoring
points.
Continuity panels
You can fold the second row seat(s) directly
from the boot, after having first folded the third
row seats.
F Pull strap D to unlock the desired seat and
give the backrest a slight push forward. To
prevent any damage to the mechanism,
strap D will unclip if excessive force is
applied. It is just a matter of clipping it back
into place to make the system operational
again.
Each seat has a continuity panel at the bottom
of the backrest, which, once unfolded:
- allows for a continuous loading surface in
the boot, whatever the position of the seats,
- prevents objects from sliding beneath the
2nd row seats.
These continuity panels are not designed
to support a weight greater than 30 kg.
To Next Page
Loading...
