218
In the event of a breakdown
Fitting a wheel
F Raise the vehicle until there is sufficient
space between the wheel and the ground
to admit the spare (not punctured) wheel
easily.
F Remove the bolts and keep them in a clean
place.
F Remove the wheel.
The jack must only be used to change
a wheel with a damaged or punctured tyre.
The jack does not require any
maintenance.
The jack meets European standards,
as defined in the Machinery Directive
2006/42/EC.
List of operations
F Put the wheel in place on the hub.
F Screw in the bolts by hand to the stop.
F Pre-tighten the security bolt using
wheelbrace 1 fitted with security socket 5
(according to equipment).
F Pre-tighten the other bolts using the
wheelbrace 1 only.
F Lower the vehicle again fully.
F Fold jack 3 and detach it.
To Next Page
Loading...
