216
In the event of a breakdown
Putting the winch carrier and
spare wheel back in place
When the spare wheel is fitted in place of
a wheel with a punctured tyre, the winch
and tool box must be refitted underneath
the vehicle again before restarting.
F Straighten the wheel.
F Place the appropriate tools in the box and
close the cover again.
F Place the tool box on the ground.
F Pass the connecting piece through the
wheel hub (A).
F Insert the connecting piece into the tool box
hole (B – C).
F Centre and position the spare wheel on the
tool box (D).
F Insert the centring guide into the wheel hub.
F Place the wheel/box assembly beneath the
rear of the vehicle.
F Replace the wheel/box assembly beneath
the vehicle by "loosening" the winch control
nut with the wheelbrace and extension.
F Tighten fully. When the cable is completely
reeled in, turning the nut no longer
encounters resistance.
F Check that the wheel is properly flattened
against the floor.
To Next Page
Loading...
