66
Ease of use and comfort
Each of the two boards can support
a maximum load of 100 kg.
Folding the concertina
boards
Pull the strap, the 3 parts of the board fold into
concertina form.
When the third row seats are straightened,
these folded concertina boards can be left:
- either flat behind the seats,
- or in the vertical position,
thus clearing the inside of the seat as a storage
space.
Installing the seats Seat storage
F Remove the load space cover.
For more information on the Interior
fittings and particularly on the load space
cover, refer to the corresponding section.
F Straighten the continuity panels of the
second row of seats and lock them in place.
F Fold the concertina board and straighten it
vertically.
F Pull strap F, located behind the backrest
of the seat. The backrest tilts backwards
bringing the cushion. The seat locks in the
open position.
F Straighten the continuity panels of the
second row of seats and lock them in place.
F Lower the head restraints.
F Correctly position the concertina board
vertically behind the seat.
F Make sure that the seat belts of the 3
rd
row
of seats are correctly fastened to the loops
and that they do not have any creases.
F Pull strap G, located at the bottom of the
backrest of the seat. The seat is unlocked.
F Then, push the backrest slightly forwards.
The backrest tilts and folds on the cushion.
The folded seat is arranged at the back of
its storage area provided for this purpose.
F Put the concertina boards back above the
folded down seats.
To Next Page
Loading...
