161
6
Driving
Exceeding the programmed
setting
It is possible to exceed the speed setting
temporarily by depressing the accelerator
pedal.
The cruise control no longer manages the
braking system during this period.
Simply release the accelerator pedal to return
to the programmed speed.
If the programmed speed setting is exceeded,
the display of the speed setting disappears
and a message "Cruise control suspended"
is displayed until the accelerator pedal is
released.
Driving situations and
associated alerts
To benefit from all necessary information on
the instrument panel, you must select the
"DRIVING" display mode beforehand.
The table below describes the alerts and
messages displayed depending on the driving
situation.
The display of these alerts is not sequential.
Indicator lamp Display Associated message Comments
(grey)
"Cruise control paused" System paused.
No vehicle detected.
(grey)
"Cruise control paused" System paused.
A vehicle has been
detected.
(green)
according to
the inter-vehicle
distance selected
"Cruise control on" System activated.
No vehicle detected.
(green)
according to
the inter-vehicle
distance selected
"Cruise control on" System activated.
A vehicle has been
detected.
or
(green)
"Cruise control
suspended"
System activated.
The driver has
temporarily taken
control of the vehicle by
accelerating.
To Next Page
Loading...
