CITROEN C8 2002 - RHT-4 HW Valve Timing: Final Setting Checks; Timing Setting Verification

67
CHECKING AND SETTING THE VALVE TIMING
Engines : RHT-4HW
B1EK1T0D
Checking the timing setting.
Effect two turns of the engine in the normal direction of rotation, without turning the engine
backwards.
Refit the peg [2].
IMPERATIVE : Check visually that the offset between the hole in the camshaft hubs
and the corresponding pegging hole is not more than 1 mm.
Remove the peg [2].
Refit:
- The lower timing cover.
- The elements (3) of the timing cover.
- The engine support (4).
- The screws (13), tighten to 6.1 ± 0.6 m.daN.
- The nut (12), tighten to 4.5 ± 0.4 m.daN.
IMPERATIVE : Apply an opposite torque at (A).
Refit:
- The torque reaction rod (1).
- Screw (14), tighten to 5 ± 0.5 m.daN.
- Screw (15), tighten to 5 ± 0.5 m.daN.
ENGINE