CKD Xeroaqua GX Series - Page 26

＜ SM-13235-A ＞
-25-

Condition Causes Measures
Stopvalvebefore/afterthedryeris
closed.
Fullyopenthevalve.
ScreenforY-typestraineratthe
dryerinletisclosed.
Cleanthescreen.
(GX8000)
Treatedflowrateistoolarge. Make1.3orlesstimesofratedflow
Pressure drop before/after the dryer is
toolarge.
Congelationinthedrayer.
・ Ambienttemperatureislow.
・ Inlettemperatureislow.
・ Coolingwinddirectlyblowtothe
dryer.
Preventcongelation.
・ Raisetheambienttemperature. 
・ Raisetheinlettemperature.
・ Donotletcoolingwinddirectlyblow
tothedryer.
Powersupplyisturnedoff. Turnonthepowersupply.
All the lamps turn
off, and the dryer
stops.
Powersupplyvoltageisabnormal. Adjustthevoltage.
Safetydeviceison.
・ Ambienttemperatureishigh.
・ Inlettemperatureishigh.
・ Inletpressureislow.
・ Treatedflowrateislarge.
・ Dustfilterisclogged.
・ Fanmotorisbad.
・ Solenoidvalveforliquid
injectionisbad.（ＧＸ８０００）
Unusualcauseisremovedandreset.
・ Lowertheambienttemperature.
・ Lowertheinlettemperature.
・ Raisetheinlettemperature.
・ Lowerthetreatedflowrate.
・ Cleanthedustfilter.
・ Replacethefanmotor.
・ Replacethevalveforliquidinjection.
（ＧＸ８０００）
Remotestopwaspushedduring
manualoperation. 
Restartthemanualoperation.
Thedryer
 suddenlystops.
Only“POWER”lamp
ison.
Manualstopwaspushedduringthe
remoteoperation.
Restarttheremoteoperation.
