EasyManuals Logo

Clack V1CIDME-M03 User Manual

Default Icon
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #20 background imageLoading...
Page #20 background image
Page 20 CI Man u al
STEP 1U
STEP 2U
STEP 3U
RETURN TO NORMAL MODE
Set Time of Day
The user can also set the time of day. Time of day should only need to be set after power outages lasting more than 24 hours, if
the battery has been depleted and a power outage occurs or when daylight saving time begins or ends. If a power outage lasting
more than 24 hours occurs, the time of day will ash on and off which indicates the time of day should be reset. If a power outage
lasts less then 24 hours and the time of day ashes on and off, the time of day should be reset and the non rechargeable battery
replaced.
STEP 1U – Press SET CLOCK.
STEP 2U - Current Time (hour): Set the hour of the day using or . Press NEXT to go to
Step 3U.
STEP 3U - Current Time (minutes): Set the minutes of the day using or . Press NEXT to exit
Set Clock. Press REGEN to return to previous step.
Regeneration Mode
Typically a system is set to regenerate at a time of low water usage. An example of a time with
low water usage is when a household is asleep. If there is a demand for water when the system is
regenerating, untreated water will be used.
When the system begins to regenerate, the display will change to include information about the step of the regeneration process
and the time remaining for that step to be completed. The system runs through the steps automatically and will reset itself to
provide treated water when the regeneration has been completed.
Manual Regeneration
Sometimes there is a need to regenerate the system sooner than when the
system calls for it, usually referred to as manual regeneration. There may
be a period of heavy water usage because of guests or a heavy laundry day.
To initiate a manual regeneration at the preset delayed regeneration
time, when the regeneration time option is set to “NORMAL” or “NORMAL + on 0”, press and release “REGEN”. The words
“REGEN TODAY” will ash on the display to indicate that the system will regenerate at the preset delayed regeneration time. If
you pressed the “REGEN” button in error, pressing the button again will cancel the request. Note: If the regeneration time option
is set to “on 0” there is no set delayed regeneration time so “REGEN TODAY” will not activate if “REGEN” button is pressed.
To initiate a manual regeneration immediately, press and hold the “REGEN” button for three seconds. The system will begin to
regenerate immediately. The request cannot be cancelled.
Note: For softeners, if brine tank does not contain salt, ll with salt and wait at least two hours before regenerating.
REGEN TODAY will be
displayed if a regeneration
is expected “Tonight.”

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Clack V1CIDME-M03 and is the answer not in the manual?

Clack V1CIDME-M03 Specifications

General IconGeneral
BrandClack
ModelV1CIDME-M03
CategoryControl Unit
LanguageEnglish

Related product manuals