To Next PageTo Next Page
Need help?Do you have a question about the Clack WS2H and is the answer not in the manual?
General| Model | WS2H |
|---|---|
| Manufacturer | Clack Corporation |
| Max Pressure | 125 psi |
| Brine Line Connection | 1/2" NPT |
| Drain Line Connection | 1/2" NPT |
| Riser Tube Diameter | 1.05" |
| Regeneration | Downflow |
| Valve Type | Piston-operated |
| Temperature Range | 34°F - 110°F |
| Backwash Duration | 10 Minutes |
| Cycle Options | Adjustable cycle times |
| Flow Rate | 27 gpm (6.1 m3/h), Backwash: 27 gpm (6.1 m3/h) |
Covers unit selection, number of units, and system type configuration.
Details pre-service rinse, isolation timing, and alternate regeneration sequence.
Covers isolation type, day override, and regeneration control settings.
Details reserve calculation, auxiliary input, meter calibration, and drive settings.
Covers volumetric capacity, days between regenerations, and delayed regeneration times.
Configures 7-day time clock options for regeneration scheduling.
Provides crucial safety and handling instructions for installation.
Guides on connecting water lines and recommended bypass installation.
Details drain line setup, brine port connection, and regenerant overflow.
