To Next PageTo Next Page
Need help?Do you have a question about the Clack WS1 25CI Series and is the answer not in the manual?
General| Model | WS1 25CI Series |
|---|---|
| Category | Control Unit |
| Inlet/Outlet | 1" NPT |
| Timer Type | Electronic |
| Service Flow Rate | 25 GPM |
| Backwash Flow | 5.0 GPM |
| Operating Pressure | 20 - 125 psi (1.4 - 8.6 bar) |
| Connection Size | 1" |
| Drain Line | 1/2" |
| Brine Line | 3/8" |
| Riser Tube Diameter | 1.05" |
| Materials | Noryl |
Essential safety guidelines and specifications for OEM manuals.
Explains the valve's operation and the sequence of regeneration cycles.
Details on drive, cap, piston, spacer stack, injector, and refill assemblies.
Information on drain line controls, water meters, mixing valves, and bypass valves.
OEM instructions for cycle sequence, softener, and filter system setup.
Configuration of display parameters, hardness, and regeneration timing.
Explains user displays, regeneration modes, and manual regeneration.
Procedures for setting time, managing salt, and handling power loss.
Accessing diagnostic data and system status information.
Viewing historical operational data such as days, regenerations, and volume.
Exploded views and part lists for valve assemblies and components.
Visual representations of water flow during various valve cycles.
Detailed instructions for servicing drive, cap, piston, injector, meter, and bypass.
Guide to identifying and resolving common valve problems and error codes.
Outlines the terms and conditions of the limited warranty for control valves.
