Clack WS1 25CI Series - Diagnostics and Valve History; Diagnostic Procedures

Page 26 WS1CI & WS1.25CI Manual
Valve History
STEP 1VH – Press ▲ and ▼ simultaneously for three seconds and release. Then press ▲ and ▼
simultaneously and release. If screen in step 2VH does not appear in 5 seconds the lock on the valve
is activated. To unlock press ▼, NEXT, ▲, and SET CLOCK in sequence, then press ▲ and ▼
simultaneously for 3 seconds and release. Then press ▲ and ▼ simultaneously and release.
STEP 2VH
9
– Days, total since start-up: This display shows the total days since startup. Press the NEXT
button to go to Step 3VH. Press REGEN to return to previous step.
STEP 3VH – Regenerations, total number since start-up: This display shows the total number of
regenerations that have occurred since startup. Press the NEXT button to go to Step 4VH. Press REGEN
to return to previous step.
STEP 4VH – Volume, total used since start-up: This display shows the total volume of water treated
since startup. This display will equal zero if a water meter is not installed. Press the NEXT button to exit
Valve History. Press REGEN to return to previous step.
9
Values in steps 2VH through 4VH cannot be reset.
➟
➟
STEP 1VH
STEP 2VH
STEP 3VH
STEP 4VH
RETURN TO
NORMAL MODE
➟
➟
➟