Page 24 WS1CI & WS1.25CI Manual
Power Loss
If the power goes out for less than two hours, the system will automatically reset
itself. If an extended power outage occurs, the time of day will fl ash on and off which
indicates the time of day should be reset. The system will remember the rest.
Error Message
If the word “ERROR” and a number are alternately fl ashing on the display contact the
OEM for help. This indicates that the valve was not able to function properly.
➟
➟
STEP 1US
STEP 2US
STEP 3US
➟
➟
RETURN TO
NORMAL MODE
Salt Remaining or Adding Salt
If the Low Salt Warning was activated in the last step of OEM Softener System Setup the following screens will be viewed in the
User Display.
Note: The salt used per regeneration setting can be set in increments of 0.05 Kg, but the Kg REMAINING screen will round up or
down to the closest whole number.
Once the salt remaining has gone below the set point the display will automatically fl ash Salt Fill.
When adding salt to the brine tank (if the salt remaining feature is activated) the following steps must be completed:
➟
➟
or
Step 1US – Press the NEXT button until SALT appears in the display. It does not matter if the SALT
display alternates with the Kg REMAINING display.
Step 2US – Press SET CLOCK.
Step 3US – Set Kg REMAINING: Use the ▼ or ▲ button to adjust the Kg remaining in the brine tank.
NOTE: Estimate the Kg of salt in the brine tank and add it to the amount of salt added to the brine
tank. The example at the left would indicate 100 Kg of salt being added to a brine tank that has 20 Kg
remaining.
Step 4US – Press SET CLOCK to exit Adding Salt.
STEP 4US
➟
To Next Page
Loading...
Need help?
General
