Need help?Do you have a question about the Clack V1CIDMF-03 and is the answer not in the manual?
General| Manufacturer | Clack |
|---|---|
| Model | V1CIDMF-03 |
| Type | Control Unit |
| Max Current | 1.5 A |
| Operating Temperature | 1° – 49° C |
Procedure to start OEM Cycle Sequence setup using button combinations.
Choose the correct valve size for the OEM Cycle Sequence.
Specify the flow meter type for the OEM Cycle Sequence.
Start OEM Softener System Setup and select Softening mode.
Set cycle times for Backwash, Brine, Rinse, and Fill phases.
Set system capacity, volume capacity, and regeneration time options.
Configure Relay 1 operation mode and actuation/deactivation timing.
Set deactivation times for Relay 1 and operation/timing for Relay 2.
Configure the low salt warning feature for the system.
Start OEM Filter System Setup and select Filtering mode.
Set cycle times for Backwash, Brine, Rinse, and Fill phases.
Set volume capacity and regeneration time options for filter system.
Configure Relay 1 operation mode and actuation/deactivation timing.
Begin the Installer Display Settings procedure.
Set influent and service water hardness for display.
Set the day override for regeneration initiation.
Set the hour and minutes for the next regeneration time.
Initiate regeneration manually, either at a preset time or immediately.
Set the current time of day after power outages or daylight saving changes.
Steps to add salt and update the remaining salt display.
Information on system behavior during power loss and error message interpretation.
Begin the diagnostic data viewing procedure.
Display days and volume treated since last regeneration.
Show 7-day reserve capacity usage and 63-day usage history.
Display history of tank transfers for twin tank systems.
Display maximum flow rate in liters per minute over last seven days.
Show history of MAV drive movements for extended and retracted positions.
Begin the valve history data viewing procedure.
Display the current software version of the control valve.
Show total days, regenerations, and volume treated since startup.
Provide history of the last 10 errors generated by the control.
To Next Page
