Page 22 CI Man u al
STEP 1D
STEP 2D
STEP 3D
STEP 1D – Press ▲ and ▼ simultaneously for three seconds. If screen in step 2D does not appear
in 5 seconds the lock on the valve is activated. To unlock press ▼, NEXT, ▲, and SET CLOCK in
sequence, then press ▲ and ▼ simultaneously for 3 seconds.
Diagnostics
STEP 6D – Twin Tank Valve Transfer History only displays when
1.0 was selected in Step 2CS. Use ▲ or ▼ to scroll through the last
10 tank transfers.
The fi rst position in the display ranges from 0 to 9 with the lowest number being the most recent
transfer. The second position in the display will be either “A” or “b”. If “A” then the tank with the
valve on it was in service, if “b” the tank with the in/out head on it was in service. The next three
digits represent the number of hours ago that the transfer occurred. The display alternates with the
volume that was treated before the tank transferred. Press NEXT at any time to go to Step 7D. Press
REGEN to return to previous step.
STEP 5D - Volume, 63-day usage history: This display shows day
1 (for yesterday) and fl ashes the volume of water treated yesterday.
Pressing ▲ will show day 2 (which would be the day before
yesterday) and fl ashes the volume of water treated on that day.
Continue to press ▲ to show the maximum volume of water treated
for the last 63 days. If a regeneration occured on the day the word
“REGEN” will also be displayed. This display will show dashes if
a water meter is not installed. Press NEXT at any time to go to Step 6D. Press REGEN to return to
previous step.
STEP 4D – Volume, reserve capacity used for last 7 days: If the
valve is set up as a softener, a meter is installed and Set Volume
Capacity is set to “Auto,” this display shows 0 day (for today) and
fl ashes the reserve capacity. Pressing ▲ will show day 1 (which
would be yesterday) and fl ashes the reserve capacity used. Pressing
▲ again will show day 2 (the day before yesterday) and the reserve capacity. Keep pressing ▲ to
show the capacity for days 3, 4, 5 and 6. ▼ can be pressed to move backwards in the day series.
Display does not appear if 1.0 is selected in Step 2CS. Press NEXT at any time to go to Step 5D.
Press REGEN to return to previous step.
STEP 5D
STEP 6D
STEP 3D – Volume, since last regeneration: This display shows the volume of water that has been
treated since the last regeneration. This display will equal zero if a water meter is not installed. Press
NEXT to go to Step 4D. Press REGEN to return to previous step.
STEP 2D
– Days, since last regeneration: This display shows the days since the last regeneration
occurred. Press NEXT to go to Step 3D. Press REGEN to exit Diagnostics.
STEP 4D
To Next Page
Loading...
Need help?
General
