Clarion ADZ625 - 10 ERROR Displays

If an error occurs, one of the following displays is displayed.
Take the measures described below to eliminate the problem.
IirrQf>Display
l
ERROR 2
ERROR 3
ERROR 6
ERROR 1
ERROR 2
ERROR 4
ERROR 8
A CD is caught inside the CD deck and is
not ejected.
A CD cannot be played due to scratches,
etc.
A CD
is loaded upside-down inside the
CD deck and does not
play.
Tape cannot be played due to defective
tape such
as cut tape.
Tape
is caught and cannot be played.
Tape mode cannot be detected.
Tape
is caught and cannot be ejected.
Measure
This is a failure of CD deck's mechanism
and consult your store of purchase.
Replace with a non-scratched,
non-warped-disc.
Eject the disc then reload
it properly.
Eject the tape then replace it with a new
one.
Remove the caught or wound tape.
This
is a failure of tape mechanism and
consult your store of purchase.
Eliminate the reason for which the tape is
caught.
ERROR 2
ERROR 3
ERROR 6
ERROR H
ERROR 2
ERROR 3
ERROR 6
A CD inside the CD changer is not
loaded.
A CD inside the CD changer cannot be
played due to scratches, etc.
A CD inside the CD changer cannot be
played because
it is loaded upside-down.
Displayed when the temperature
in the
MD changer
is too high and playback has
been stopped automatically.
An MD inside the MD changer is not
loaded.
An MD inside the MD changer cannot be
played due to scratches, etc.
An MD inside the MD changer cannot be
played because
it is loaded upside-down.
Displayed when a non-recorded MD
is
loaded in the MD changer.
This is a failure of CD changer's
mechanism and consult your store of
purchase.
Replace with a non-scratched, non-
warped disc.
Eject the disc then reload it properly.
Lower the surrounding temperature and
wait for a while to cool off MD changer.
This
is a failure of MD changer's
mechanism and consult your store of
purchase.
Replace with a non-scratched, non-
warped disc.
Eject the disc then reload it properly.
Load a pre-recorded MD
in the MD
changer.
If an error display other than the ones described above appears, press the reset button. If the problem
persists, turn off the power and consult your store of purchase.
AOZ625 27