Problem
Cause
Replace with a fuse of the same amperage. If
the fuse blows again, consult your store of pur-
chase.
Consult your store of purchase.
Power antenna lead is shor-
ted to ground or excessive
current is required for re-
mote-on the amplifiers or
power antenna.
Incorrect wiring.
No sound output
when operating the
unit with amplifiers or
power antenna at-
tached.
Power does not turn Fuse
is
blown.
on.
(No sound is pro-
duced.)
1.
Turn the unit off.
2.
Remove all wires attached to the power anten-
na lead.
Check
each wire for a possible short
to ground using an ohm meter.
3.
Turn the unit back on.
4.
Reconnect each amplifier remote wire to the
power antenna lead one by one. If the amplifi-
ers turn off before all wires are attached, use
'i!
an external relay to provide remote-on voltage
ep
(excessive current required).
c
epl-------------If------------t---------------------,I
CD
Nothing happens The microprocessor has Press the reset button with a thin rod.
when buttons are malfunctioned due to noise,
pressed. etc.
Display is not accu-
rate.
Compact disc cannot Another compact disc is al- Eject the compact disc before loading the new
be loaded. ready loaded. one.
Sound skips or is no
i-
Compact disc is dirty.
sy.
Clean the compact disc with a soft cloth.
Q
(.)
Compact
disc
is heavily
scratched
or
warped.
Replace with a compact disc with no scratches.
Sound is bad directly
after
power
is turned
on.
Water droplets may form on Let dry for about
1 hour with the power on.
the internal lens when the
car is parked
in
a humid
place.
Sound quality is poor. Playback head
is
dirty.
Use a cleaning tape, etc., to clean the head.
ep
.~
I!J.
[ROM]
button is not pres-
sed.
When listening to a tape recorded with Dolby
NR, press
[ROM]
button and select B NR.
26
ADZ625
To Next Page
Loading...
