ASSEMBLY
1.Processing of Panel ASSY
1-1.Installation of SD Cover
NO. Q'TY
1.Install the SD cover③and SD bracket②on the ① 1
② 1
③ 1
④ 1
1-2.Installation of Light Guide
1.Install the knob light guide①, press and ① 1
1-3.Installation of Lens&Silver Part
1. Install Silver part①, press to ① 1
fasten it and use iron to fix the ② 1
positioning bar. ③ 1
2. Place the double sided tape③ on the ④ 1
bracket④, place the top lens② on the brak ⑤ 1
3. Place the double sided tape⑤ on the ⑥ 1
front panel, and stick the bottom lens⑥
1-4.Installation of Touch screen
①
4 the bubble cushion should
②
3 not be within the touch
③
1
④ 1
⑤ 1
1-5.Installation of TFT Module
1. Install the touch screen and TFT module ① 1
fasten it, then use the iron to fix the
positioning bar.
into the front bracket.
1. Stick on each side of the touch screen
121490000449
the bubble cushion along each edge.
sensor area.
121490000758
121455010053
2. Stick the protective film on the touch
141270500495017
141220000578018
to the tape.
121260000645000
121445000254
121240001153000
121445000274
141220000583018
121490000448
143490000122
front panel①, press to fasten them and use iron
to fix the positioning bar; place the cushion④
(make sure it stick to SD bracket② red side.)
121460000521
141210001345028
143420010072
screen.
121290002367000
PARTS NUMBERWORKING DIAGRAM WORKING PROCESS WORKING POINT
121240001155000
①panel
② SD Bracket
③SD Cover
④PET SHEET
⑥bot lens
②Toplens
③Tape
Li
ht
uide
Ta
e
Bracket
①Silver part
① Puron×4
②Puron×3
②
②
③Touch
Screen
④Puron
⑤ Film
TFT Module
To Next Page
Loading...
Need help?
General
