Clarion NZ502E - General Cautions; Cautions on Installation

30 NZ502E
English
English
General Cautions
1. Do not open the case. There are no user- serviceable
parts inside. If you drop anything into the unit during
installation, consult your dealer or an authorized
Clarion service center.
2. Use a soft, dry cloth to clean the case. Never use
aroughcloth,thinner,benzine,oralcoholetc.For
tough dirt, apply a little cold or warm water to a soft
cloth and wipe off the dirt gently.
Cautions on Installation
1.Prepareallarticlesnecessaryforinstallingthe
source unit before starting.
2. This model features an operation panel that slides
forward.
On some types of cars, the operation panel may
make contact with the dashboard or gearshift
lever, in which cause it cannot be installed. Before
installing, check that the unit will not hamper
operation of the gearshift lever or obstruct your view
beforeselectingtheinstallationlocation.(Figure2)
3. Install the unit within 30° of the horizontal plane.
(Figure3)
4. If you have to do any work on the car body, such as
drilling holes, consult your car dealer beforehand.
5. Use the enclosed screws for installation. Using
otherscrewscancausedamage.(Figure4)
NZ502E
Figure3
NZ502E
Figure2
Gearshiftlever
(Checkthatitdoesnot
touchtheLCD)
Dashboard
Gearshiftlever
Figure4
Chassis Chassis
Damage
Max.8mm(M5screw)
NZ502E_quick start guide_120718.indd 30 2012-7-18 13:48:50