Clarion NZ502E - Cautions on Wiring

33NZ502E
English
English
Cautions on Wiring
1. Be sure to turn the power off before wiring.
2. Be particularly careful where you route the wires.
 Keepthemwellawayfromtheengine,andexhaustpipe,etc.Heatmaydamagethewires.
3. If the fuse should blow, check to see if the wiring is correct.
 Ifafuseisblown,replaceitwithanewoneofthesameamperageratingastheoriginal(15AFUSE).
4.Toreplacethefuse,removetheoldfuseonthebackoftheunitandinsertthenewone.(Figure8)
NOTE:
There are various types of fuse holder. Do not let the battery side touch other metal parts.
Figure8
Fuse(15AFUSE)
After the connection, fix the cord by a clamp
or insulation tape for protection.
Fuseholder
CAUTION
NZ502E_quick start guide_120718.indd 33 2012-7-18 13:48:51