Radio Operation
FM Reception
For enhanced
FM
performance the MfiGl-TUNE
® tuner includes signal actuated stereo control
and Multipath noise reduction circuits.
Listening
to the Radio
1)
Press the FUNC button
[[]
to select the radio
mode. The radio turns on.
2)
To
tune to a desired preset station, first press
the BAND button
[&J
and select FM1, FM2,
FM3, FM4 or AM.
The band changes as follows each time the
BAND button is pressed:
FM1
...
FM2
...
FM3'" FM4'"
AM
...
FM1
3)
Use the corresponding Preset buttons
[1ID
to
select the desired station.
Seek Tuning
1)
Press the BAND button
[&J
and select the
desired band.
2) Press the Up or Down buttons
[I]
to seek up
or down the frequency band. Seek tuning
automatically stops when a station
is
found.
Manual Tuning
1)
Press the BAND button
[&J
to select the
desired band.
2)
Press and hold the BAND button for more
than 2 seconds. "MANU" is illuminated on
the display and the manual tuning mode is
selected.
3)
Use the Up and Down buttons
[I]
to manual-
ly tune up or down the desired frequency
band.
8
XA311
Presetting Stations
A total of 25 stations can be preset, 5 each for
the FM1, FM2, FM3, FM4 and AM bands.
Note:
• When a station is preset, the station previously stored
in
the memory
at
that position is cleared.
Presetting
stations
manually
1)
Press the BAND button
[&J
to select the band
at which to store the station.
2)
Use the Up and Down buttons
[I]
to tune
in
the station to be preset.
3)
Press and hold the corresponding Preset
button
[1ID
for at least 2 seconds to store the
station into memory.
Auto
store
function
(Automatic
Station
Store)
1)
Press the BAND button
[&J
to select the band
at which to store the stations.
2)
Press and hold the AS button
[ID
for at least
2 seconds. Stations with good reception are
automatically stored at preset to the five but-
tons
[1ID
1 to
5.
*If there are fewer than 5 stations with good recep-
tion, the stations previously stored at the remain-
ing buttons are not cleared.
Preset Scanning (Preset Station Scan)
When the PS button
[ID
is
pressed, the preset
memory numbers
jlpsh
and the stations are
tuned
in
for 7 seconds each
in
the
order
in
which
they were stored. Press the PS button again to
cancel the preset scanning mode.
Note:
•
The
auto store mode
is
set
if
the PS button is pressed
for more than
2 seconds.
To Next Page
Loading...
