11
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
STARTING YOUR PRESSURE WASHER
1. Turn the water supply on, making sure that the tap is fully open.
2. Set the choke lever to the CLOSE
position.
3. Set the fuel supply valve to the ON
position.
4. Slide the throttle lever to the left
approximately 3/4 of the way.
WARNING: FAILURE TO TURN ON THE WATER COULD CAUSE DAMAGE TO
THE PRESSURE WASHER.
To Next Page
Loading...
