16
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
WATER BUTT CONNECTION
This machine has the ability to draw its own water, meaning you can use water
not under pressure such as rainwater collected in a water butt.
To do this you must carry out the following procedure.
1. Remove the quick connector
from the water inlet.
2. Attach the filter to the end of the
braided pipe supplied.
3. Connect other end of the filter &
pipe to the water inlet.
4. Fill the priming bottle with water.
5. Connect the hose from the bottle
to the self-suction valve shown.
6. Place the filter into the water
source and start the pressure
washer, See “Starting your
pressure washer” on page 11.
To Next Page
Loading...
Need help?
General
