Clas Ohlson CUBE 66 BT - Wired Connections

6
English
5. If you are prompted to enter aPIN code, enter 0000. Certain devices require
that you also approve theconnection.
6. Start playback on theconnected device. You should now be able to hear theaudio
from theconnected device through thespeaker, providing that thedevice is in range.
7. Turn the[ BLUETOOTH VOLUME ] (13) clockwise to thedesired level and use
the [ MASTER VOLUME ] (8) control to adjust themain volume. Adjust
thevolume level of any other used inputs, e.g. [ LINE IN VOLUME ] (1) and/or
[ MICVOLUME ](2) if needed. Turn them anti-clockwise to reduce or turn off their
input volume.
Wired connections
MIC IN
1. Connect amicrophone or instrument to MIC IN (4). This combination microphone
input accommodates aØ 6.3 mm jack plug with anunbalanced cable or
a XLR connector with balanced cable.
2. Turn the[ MIC VOLUME ] (2) clockwise to thedesired level and use
the[ MASTERVOLUME ] (8) control to adjust themain volume. Adjustthevolume
level of any other used inputs, e.g. [ LINE IN VOLUME ] (1) and/or
[ BLUETOOTHVOLUME ] (13) if needed. Turn them anti-clockwise to reduce
orturn off their input volume.
LINE-IN
1. Connect anexternal audio source to LINE IN (5) with aØ 6.3 mm jack plug or to
LINE IN (6) with aRCA cable.
2. Turn the[ LINE IN VOLUME ] (1) clockwise to thedesired level and use
the[ MASTER VOLUME ] (8) control to adjust themain volume. Adjust thevolume
level of any other used inputs, e.g. [ MIC VOLUME ] (2) and/or [ BLUETOOTH
VOLUME ] (13) if needed. Turn them anti-clockwise to reduce or turn off their
input volume.
REC OUT
Connect anexternal recording device
or PA system to REC OUT (7) using
a RCA cable. The output signal will run
independent of theset master volume
or tone setting.
I 0:00:00
LINE IN
MIC IN
REC OUT