CLAUSING MS1318M - Page 91

9-9!
*XOOHWV/RDGLQJ8S:LWK0DWHULDO
Probable Cause :
A. Too fine of a tooth pitch
insufficient gullet capacity.
B. Excessive feeding rate producing too large of a chip.
C. Worn, missing or improperly positioned chip brush.
D. Insufficient sawing fluid due to inadequate supply,
improper ratio and/or improper application.
'LVFRORUHG7LSV2I7HHWK'XH7R([FHVVLYH)ULFWLRQDO+HDW
Probable Cause :
A. Insufficient sawing fluid due to inadequate supply,
improper ratio and/or improper application.
B. Excessive band speed.
C. Improper feeding rate.
D. Band installed backwards.
+HDY\:HDU2Q%RWK6LGHV2I%DQG
Probable Cause :
A. Chipped or broken side guides.
B. Side guide adjustment may be too tight.
C. Insufficient flow of sawing fluid through the
side guides.
D. Insufficient sawing fluid due to inadequate supply,
improper ratio and/or improper application.
8QHYHQ:HDU2U6FRULQJ2Q7KH6LGHV2I%DQG
Probable Cause :
A. Loose side guides.
B. Chipped, worn or defective side guides.
C. Band is rubbing on part of the machine.
D. Guide arms spread to maximum capacity.
E. Accumulation of chips in side guides.
MS1318M / MS1318SA