CLAUSING MS1318M - Page 92

9-10!
+HDY\:HDU$QG2U6ZDJJLQJ2Q%DFN(GJH
Probable Cause :
A. Excessive feed rate.
B. Excessive back-up guide "preload".
C. Improper band tracking
back edge rubbing
heavy on wheel flange.
D. Worn or defective back-up guides.
%XWW:HOG%UHDNDJH
Probable Cause :
A. Any of the factors that cause body breaks can also
cause butt weld breaks.
(See Observations #5, #15 and #16)
+HDY\:HDU,Q2QO\7KH6PDOOHVW*XOOHWV

Probable Cause :
A. Excessive feeding rate.
B. Too slow of band speed.
C. Using too fine of a tooth pitch for the size of material
being cut.
%RG\%UHDNLQJ )UDFWXUH7UDYHOLQJ,Q$Q$QJXODU'LUHFWLRQ
Probable Cause :
A. An excessive twist type of stress existed.
B. Guide arms spread to capacity causing
excessive twist from band wheel to guides.
C. Guide arms spread too wide while cutting
small cross sections.
D. Excessive back-up guide "preload".
MS1318M / MS1318SA