30
Reassembling the Mask
1. Refit the orinasal piece – The frame of the orinasal piece has two ribs on the bottom. Fit these into the
slots in the bottom of the main valve block. Push the top of the orinasal piece firmly forwards until both
snaps engage, holding it in place against the main valve block. See Figure 31.
2. Lower the rain cover. See Figure 32.
Figure 31 – Refit the inner mask
Figure 32 – Lower the rain cover
WARNING
Using a full-face mask with the rain cover raised can cause the exhalation valve to vibrate,
which you may notice as a buzzing noise. Lower the rain cover for correct operation.
CLEANING THE POWER UNIT
• Remove the used filter. Used filters should be disposed of responsibly and treated as non-recyclable
hazardous* waste (dependent on the contaminant being filtered).
• IMPORTANT: Insert the CleanSpace Halo Cleaning & Storage Plug (CS3011) into the filter inlet and two
bellow air outlets. Using the Cleaning & Storage Plug (CS3011) prevents dust or liquids from entering the air
path of the power unit.
• Cleaning wipes or a cloth soaked with cleaning agent can be used to wipe down the outside of the power unit.
After cleaning, use a clean cloth to remove the cleaning agent.
• Allow the power unit to air dry in a clean environment. The power unit can also be dried with a clean lint-free
cloth. Note: Do not dry the power unit by exposing to heat (i.e. hair dryers or heaters) or compressed air.
• When dry, store the power unit with the Cleaning Storage Plug (CS3011) in place to prevent dust and liquids
entering the air path.
• If the power unit is to be used immediately after cleaning, insert a clean filter and lock in place ready for use.
WARNING
The power unit contains a battery, sensitive electronics and a motor. Always use the CS3011
cleaning plug when using anything wetter than a damp cloth to clean it.
CLEANING THE HARNESS AND NECK SUPPORTS
The harness and neck supports can be washed using the same methods as the half mask. After cleaning, allow the
harness and neck supports to air dry in a clean environment.
Note: Do not dry the harness or neck supports by exposing directly to heat e.g. hair dryers or heaters.
CLEANING THE VALVE COVERS (PAF-1111, CS3026) & STERI-PLUS FILTER CASE (CS3038)
The exhalation valve covers (PAF-1111 & CS3026) and the CS3038 Steri-Plus Exhalation Filter Cover can all be
cleaned using the methods described for the half mask; or disposed of and replaced with new ones, depending on
the disinfection policies of the user.
DISPOSING OF BIOHOOD, BIO EXHALATION FILTER AND STERI-PLUS EXHALATION FILTER
Neither the BioHood (CS3024) or the Exhalation Filters (CS3039, CS3027) can be cleaned. Dispose of after use.
To Next Page
Loading...
