10
SYSTEM SETUP
Displayed below is an example of a typical Clear-Com set up and conguration with the DX410.
Battery Charging
Before installing the system, connect the AC power supply to the battery charger and plug it
into an electrical outlet. Charge all the batteries while the other equipment is being installed.
Charging time is about 2.5 hours.
Connect AC Power Supply
To connect the AC power supply to the battery charger:
1. Connect the AC power supply cable connector to the
power connection on the battery charger.
2. Connect the AC power cord to an electrical outlet.
The red lights on the charger will briey display, and then the yellow
lights will appear and remain on.
To Next Page
Loading...
