Clear-Com HME DX410 - TECHNICAL DATA

27
TECHNICAL DATA
BS410 Base Station Specications
General
Channels
2 audio channels
Frequency Range
2400 – 2483.5 MHz
Frequency Response
200 Hz to 7 kHz
Power Requirements
100-240VAC, 50-60Hz or 12-14VDC
Temperature Range
32-122°F (0-50°C)
Size
19” x 1.72” x 17.13” (1-RU) (48.26 x 4.37 x 43.51 cm)
Weight
9.0 lbs. (4.1 kg) maximum
# of COMMUNICATOR
®
s per Base
15 can be registered.
In single-channel operation, 4 can have simultaneous full-duplex
communication.
In dual-channel operation, 3 can have simultaneous full-duplex
communication.
4-Wire I/O
RJ45, 600Ω balanced, level adjustable, simultaneous operation with 2-wire
2-Wire I/O
XLR-3M, XLR-3F, externally-switchable RTS
®
or Clear-Com
®
mode,
200Ω, level adjustable, null adjustable to 50dB attenuation, typical
Auxiliary Input
XLR-3F/¼” (6.35 mm) combo jack, 600Ω balanced, level adjustable
Auxiliary Output
XLR-3M, 600Ω balanced, level adjustable
Headset Connector
4-pin mini-DIN, Electret microphone
Headset Output
200mW into 32Ω
Antenna Type
External ½ -wave dipole (R-TNC connector), RX/TX horizontal/vertical
diversity
System Distortion
<2%
Communication Security
64-bit encryption, dual-slot diversity
Base Station Transmitter
Type
Frequency Hopping, Spread Spectrum (FHSS)
Transmit Power
100mW burst
Modulation Type
Gaussian ltered FSK, TDMA
Frequency Stability
13 ppm
Harmonics/Spurious
Exceeds FCC and ETSI specications over temperature
Base Station Receiver
Type: RF Sensitivity
Frequency Hopping, Spread Spectrum <-90dBm w 10-3 BER
Frequency Stability
13 ppm
Distortion
<2%