Hawk 1000 Section 3 — Hardware Checkout
Part No. 750-366 3-9
Figure 3-7. Actuator daisy chain hard wired
3.2.3 Setting The Modbus Node Address
The actuators are required to have unique Modbus node addresses. The node address is set using a rotary
style switch located on the actuator front plate. Turn to the desired address using a small, flat bladed
screwdriver.
MODBUS ACTUATORS HARD WIRED
FUEL 1
ACT. 1
FUEL 2
ACT. 1
To Next Page
Loading...