Hawk 1000 Section 4 — System Configuration
Part No. 750-366 4-13
4.4.4 Analog Inputs
Figure 4-12. Analog Inputs (steam)
Analog Input I:2.2
For Steam systems it is mandatory that Analog Input I:2.2 is Water Temperature
For Hot Water systems Analog Input I:2.2 can be selected as None, Outdoor Temperature, or Return
Temperature.
!
Caution
Revert to Pilot modes are to be determined in the field
after
careful
analysis of the load conditions that necessitate the use of these mode
of ope
r
ation.
Care should be taken to avoid
unnecessa
r
y
recycling and damage to the
boiler equipment.
To Next Page
Loading...