Hawk 1000 Section 4 — System Configuration
Part No. 750-366 4-11
4.4.2 Fuel Configuration
Figure 4-10. Fuel configuration
Number of Fuels
Enter the Number of Fuels for this application
.
Acceptable values are either 1 or 2. High/Low control method MUST be fuel 2.
Fuel 1/Fuel 2 Type
Select the Fuel type for each fuel for this specific job
When pressing the Fuel Type push button a selector is displayed
The up/down arrows can be used to select the correct fuel. Press the enter key to accept the selection.
Fuel 1/Fuel 2 Turndown
Enter the Turndown for each fuel for this specific application.
The turndown entry affects the boiler efficiency calculations - it has
no
impact on the burner's actual
turndown. Turndown ratio is established
during burner commissioning by a qualified burner
technician
.
To Next Page
Loading...