Section 4 — System Configuration Hawk 1000
4-6 Part No. 750-366
Note that if a configuration setting is marked with an asterisk and the setting is changed the Combustion
Curves will be erased.
Note: The boiler will not start while you are in the “System Config” screen.
Note: The firing rate will be put into manual mode upon entering the “System Config” screen.
4.4.1 Boiler Media and Type
The first step in the configuration procedure is to select the boiler media and type.
Any time a gray button appears, a user I.D. and password are required for user input.
Pressing <Boiler Media> or <Boiler Type> will bring up the following screen:
!
Caution
If System Configuration is entered with the boiler running, a safety
shutdown will occur. Repeated shutdowns or nuisance shutdowns
can cause premature equipment failure.
!
Caution
The following screens should only be accessed by qualified
personnel. Selections should never be made while the boiler is in
operation.
Figure 4-7. Select boiler media & type
To Next Page
Loading...