Hawk 1000 Section 4 — System Configuration
Part No. 750-366 4-5
Figure 4-6. Warning 2
Press <Next> to continue. The following items are configurable when in system configuration:
• Boiler Media Steam or Hot Water
• Boiler
Type
- Firetube, Flextube or M4/M5 boiler
• Safety Valve Setpoint
• NOx Level (PPM)
• Number of Fuels
• Fuel 1 Fuel Type
• Fuel 1 Control Type (Parallel or Single Point)
• Fuel 1 Turndown
• Fuel 2 Fuel Type
• Fuel 2 Control Type (Parallel, Single Point, or Low High)
• Fuel 2 Turndown
• Flame Safeguard Selection
• Revert to Pilot (CB120E Only)
• Revert to Pilot Signal Select (CB120E Only)
• Analog Input I:2.2
• Analog Input I:2.3
• Remote Modulation/Setpoint Signal Selection
• Dual Setpoint Selection
• Actuator Selection
• VFD Option Selection (requires additional analog input module Slot 7)
• VFD Bypass Option Selection
• O2 Analyzer (when this option is selected, type of analyzer must be specified - requires additional analog input
module Slot 7)
• O2 Trim
• Low O2 Shutdown Option
• Hot Standby Option Selection
• Combustion Air Temp Option Selection (requires additional analog input module Slot 7)
• Level Master Option selection (Steam Boiler)
• Return Water Temperature (hot water only)
• Outdoor Temp Reset Selection (hot water only)
• Selectable overview screen graphic - Firetube, Flextube, or M4/M5 boiler
To Next Page