English - 28 -
Open the Network menu and select Network Type as
OK
OK to connect.
Note: If the modem supports N mode, you should set N
mode settings.
OK
button on the remote control.
Network Type
as .
modem/router without entering a password or adding
Highlight
router option and press OK. Go to your modem/router
device and press the WPS button on it to make the
on your Display once the devices have paired. Select
OK
Internet Speed Test and press the OK button
Advanced and press the OK button to open
Save and press the OK button
Other Information
You can also enable or disable Wake On feature using
Connected or Not Connected and
controller application from the server of your mobile
device application provider.
Note: This feature may not be supported on all mobile devices.
Wake ON
Wake-on-LAN (WoL) and Wake-on-Wireless LAN
(WoWLAN) are technologies that allow a device to be
turned on or woken up by a network message(magic
packet). This message is sent to the device by a
program executed on a remote device connected to
Your Display is WoL and WoWLAN compatible. To
enable this feature set the Wake On option in the
Settings/Network menu as On and set the Quick
Standby option in the Signage>Power Up Settings
menu as Disabled. It is necessary that both the
same network. All devices must support magic packet
on the system from Access Points to the device which
sends the magic packet and the device which receives
the magic packet to wake-up. You can use any Wake-
on-LAN software available for the operating system of
your device in order to send magic packets.
In order to use this feature the Display and the
remote device should be connected at least once
time it is switched on. Otherwise this feature will be
switched into the standby mode.
How to control functionality
Enable Wake On option from Settings>Network
menu by settings as On
same network
Get the MAC address of your Display which will be
needed in order to send magic packets
Switch the Display into standby mode
Send magic packets to the MAC address of your
computers
Your Display should wake up after receiving magic
packets.
Connecting Other Wireless Devices
Your Display supports another short range wireless
connection technology too. A pairing is required before
using these kind of wireless devices with the Display
set. You should do the followings to pair your device
with the Display:
To Next Page
Loading...
