Clevo PD70PNT - Page 36

Disassembly
2 - 12 Removing and Installing the Heatsink
2.Disassembly
Heatsink Installation Procedure
1. Place the grease mylar pad and then apply the thermal grease as shown (Figure 8a).
2. Remove the grease mylar pad
and replace it with VGA mylar pad , make sure to press the VGA mylar pad
firmly in place (Figure 8b).
3. Replace the absorber pad
(Figure 8c).
4. Place the grease mylar pad in the heatsink and apply the thermal grease in the area as shown (Figure 8d).
5. Remove the grease mylar pad (Figure 8e).
1
2
1
3
4
5
6
5
a. d.
2
b.
6
6
6
6
c.
e.
1
3
4
5
5
Figure 8
Heatsink Installation
a. Place the grease mylar
pad and apply thermal
grease.
b. Remove the grease my-
lar pad and replace it
with VGA mylar pad.
c. Replace the absorber
pad
d. Place the grease mylar
pad and apply thermal
grease.
e. Remove the grease my-
lar pad.

1.Grease Mylar Pad
3.VGA Mylar Pad
4.Absorber Pad
5.Grease Mylar Pad