CLIMAVENETA EVOLUTION - Status Screens Navigation; Accessing Status Screens

6
English
TERMINAL EVOLUTION
STATUS SCREENS
Starting from the main screen, pressing the UP/DOWN buttons
accesses the other status screens, which are, in order:
A
WATER VALVE STATUS/OPTIONAL PROBE READ-
INGS:
screen displaying the temperature values read by the
optional probes (outlet air temperature probe, chilled water
temperature probe, hot water temperature probe, outside air
temperature probe) and the percentage of opening of the
cold and hot water modulating valves;
B
LAN STATUS:
screen displaying the status of all the units
connected in the LAN;
C
HUMIDIFIER STATUS: screen displaying the status of the
humidifier, with all the technical operating values;
D
SET POINTS: screen displaying the active control set point;
from this screen, pressing PRG and entering the first level
password, accesses a further screen used to modify the set
point and proportional band corresponding to each type of
active control (cooling, heating, dehumidification, humidifica-
tion);
E
OPERATING HOURS:
screen displaying the total operating
hours of the devices installed on the unit; from this screen,
following the instructions shown on the display and after
entering the first level password, the operating hours for each
device can be reset (set to zero), or the thresholds for acti-
vating the maintenance signal can be changed;
F
NUMBER OF STARTS: screen displaying the total number
of activations for the devices installed on the unit; from this
screen, following the instructions shown on the display and
after entering the first level password, the number of starts
for each device can be reset
G
LOG ACCESS: screen for accessing the display of the alarm
log;
H
SOFTWARE INFO: screen displaying information on the
software installed.