CLIVET HWM-2-XMi 140 User Manual

24
04:27 27-05-2019 sun
OK CONFIRM
HB01# E1
Communication fault between controller and hydro
box.
SERVICE INFORMATION
PARAMETER
ROOM SET TEMP.
MAIN SET TEMP
TANK SET TEMP.
ROOM ACTUAL TEMP.
-°C
45°C
40°C
-°C
SERVICE
CALL
ERROR
CODE
DISPLAY
SCROLL
1/2
SERVICE INFORMATION
PARAMETER
TIME
DATE
LANGUAGE
BACKLIGHT
18:39
03-06-2019
EN
ON
SERVICE
CALL
ERROR
CODE
DISPLAY
SCROLL
1/2
SERVICE INFORMATION
PARAMETER
SCREEN LOCK TIME
ON
300 SEC
SERVICE
CALL
ERROR
CODE
DISPLAY
2/2
SERVICE INFORMATION
PARAMETER
MAIN ACTUAL TEMP.
TANK ACTUAL TEMP.
25°C
25°C
SERVICE
CALL
ERROR
CODE
DISPLAY
SCROLL
2/2
Press OK to show the mean of the error code：
Please contact your dealer.
NOTE:
A total of twenty fault codes can be recorded.
The parameter function is used to display the main
parameter, and there are two pages to show the
parameter:
The DISPLAY function is used to set the interface:
SCROLL
ON/OFF
ON/OFF
BUZZER
Use ''OK'' to enter and use ''◄'', ''►'', ''▼'', ''▲'' to scroll.
6.7 OPERATION PARAMETERS
Spot check the operating parameters of the hydro
module and some operating parameters of the ODU.
This menu is for installer or service engineer reviewing
the operation parameter of hydro box and ODU units.
At the home page, go to ''MENU'' > ''OPERATION
PARAMETERS''.
Press ''OK''. There are six pages for the operating
parameter as following. Use ''▼'', ''▲'' to scroll.
OPERATION PARAMETERS
HYDRO BOX
OUTDOOR UNITS
OK ENTER SCROLL
SCROLL
1/6
OFF
0.0 A
0 HZ
1 MIN
95 MIN
3 MIN
OPERATION PARAMETERS
OPERATION MODE
COMPRESSOR FREQUENCY
COMP. RUN TIME 1
COMP. RUN TIME 2
COMP. RUN TIME 3
CURRENT
SCROLL
2/6
80 Hrs
0 P
0 P
25°C
25°C
25°C
OPERATION PARAMETERS
COMP. RUN TIME 4
EXPANSION VALVE 2
TWOUT
TWIN
TTANK
EXPANSION VALVE 1
The parameters of hydro box are as follows:
M0WU00002-00

CLIVET HWM-2-XMi 140 Specifications

General

Brand	CLIVET
Model	HWM-2-XMi 140
Category	Control Unit
Language	English